Computer case wires are very small, and they are nothing else but connectors for the plugs that are located on the motherboard.īefore proceeding directly to connecting the front panel to the motherboard, it is necessary to determine which wire is responsible for performing this or another task. Computer front panel: connecting USB connectors and 3.5 mmĬomputer front panel: principles of connectingĪs a start, it should be noted that several wires (pins) should be going from the computer case. Computer front panel: connecting power buttons and indicators 3. Computer front panel: principles of connecting 2. As soon as you do, you can remove the screwdriver and the PC will boot.Table of contents: 1.
If you have the cable connected, disconnect it, and what you should do is with a screwdriver (preferably flat), simply touch both pins at the same time.
Normally you will have the POWER SW cable of the box connected to these pins, since this is the cable that is precisely linked to the Power button of the box and that is what makes the PC turn on. You should look for where the Power Switch connector (POWER_SW, PWR_SW or PWSW) connects to it, usually in the lower right area of the motherboard. Do not impose the word short circuit because there is no problem in doing it, nor risk if you do it well, since what we will do is simply connect the power pins of the motherboard with each other.įor this you will need a flat screwdriver with a plastic handle (although it is obvious, the handle is very important) and you must locate the connection panel of the motherboard, where the cables of the box are connected. This method involves shorting the motherboard pins to force a boot. The second method carries a little risk, so we only recommend doing it if you see the urgent need to start the PC in any case.
0 kommentar(er)
